'tis my now page...

Sup...? Long time... brah.

Extreme recording endeavor brah... as I have no access to the equipment (by design), so I made a hard shift. Brah... it fits in my pocket!

tl;dr

IEM Recording Setup (Live Capture Chain)

Goal
Independently record my own in-ear monitor mix at live shows without relying on the house sound engineer or any network-dependent workflow.

Gear List

QtyItemPurpose
1Zoom H1 XLR32-bit float stereo field recorder with XLR/TRS combo inputs + 3.5mm line/mic in
2SanDisk Ultra 64GB microSDXC UHS-IPrimary and backup storage (~46h 15m record time per card at high quality)
2J&D X002SBDJ0X 3.5mm TRS Stereo Y-SplitterSignal duplication: one output to IEMs, one to recorder

Signal Flow

IEM Bodypack Headphone Out
├─ [3.5mm TRS Y-Splitter]
│  |─ Male #1 > IEMs (direct, as usual)
│  └─ Male #2 > H1 XLR 3.5mm Line Input
└─ H1 XLR records full stereo mix via 32-bit float WAV

Key Configuration Notes

SettingValue
Input Select3.5mm Stereo Line (not Mic)
Recording Format32-bit float WAV (unclickable by design)
SD CardFormat in H1 XLR before first use
Hold SwitchEngage before hitting stage to prevent accidental stops

Why This Works

  • No sound engineer cooperation required — captures what you actually hear
  • 32-bit float eliminates clipping worries — gain staging is essentially set-and-forget
  • Fully offline, battery-powered — no laptop, no WiFi, no venue power dependency
  • Redundancy built in — spare cable + spare SD card = single-point-of-failure immunity

Post-Gig Workflow

  1. Remove SD card from H1 XLR
  2. Insert into desktop card reader, or USB-C to PC
  3. Import WAV directly into Reaper (no conversion needed)
  4. Archive and compare against the original IEM experience

Total Investment
~$230 USD (recorder + 2× cards + 2× splitters)

But enough about me brah... how you been?

now: 2026.11.18